Just a few words of warning after using this TAP for the first time.
I upgraded my firmware (finally
) to Bastille, rebooted without TAPs and did a factory reset. I then listed the Channels and LCNs I wanted to remove, and added them to the ChannelRemover.txt from the zipfile. I then ran the TAP, got the screen and... nothing - no channels or LCNs removed.
So I tinkered around with the file, changing the case, the order, trying just channels, all with no result. I read all the thread, and noticed that someone else had had a similar problem using the txt file from the archive, so I created one from scratch. I took the names list from earlier in the thread, used Channels, but didn't use LCNs or the Duplicates functionality. I ran the TAP and it worked, but... the Toppy rebooted - I might have been on one of the duplicate channels I was trying to remove
So after VF&F and loading some TAPs, I made sure I wasn't on one of the duplicate channels, ran it again. It went through to the end with the message to reboot. I pressed power-off and the screen went blank, but the Toppy was still on with the clock on the display.
So, I turned it off at the mains, restarted, factory reset, rescanned, ran the TAP and... it worked
Next time, I should be able to rescan and get it working within a few minutes.