For discussions about development of TAPs, patches and other software for the Toppy

Moderator: Technical

Post Reply
Geoff Bacon
Frequent contributor
Posts: 4663
Joined: Fri Jan 12, 2007 12:21 am
Location: Bristol

Download and run a tap over Serial interface?

Post by Geoff Bacon »

I know you can download firmware over the serial link but does anyone know if it is possible to load a tap into memory via the link and then get it to run ? i.e. without copying it to disk first.

< TAP and patch development ~ Command Console - hidden commands implies that one could patch the tap into memory but doesn't show how one could then execute it. Also, I'm not sure where one would load the tap in memory and whether or not it would need changes to "relocate" it.

My gut feel is that it is probably not easily possible but, if it is, it would allow diagnostic taps to be run without needing the tap to be present on the disk e.g. a tap to check the file structure
Note: I know that "exec <tap>" could be used to run a tap that is already on the disk in \ProgramFiles (but it doesn't work on my toppy!)

TopManager program
TF5800, TS On, F/W: MS6 Recommended F/W 12/9/2009 -Sy+EvEzPePfUUuZ
TAPs: PcControl B1.4; StopExit v1.01; MHEG On/Off A3; QuickJump 1.72; EIT Sub (Game) v0.6; SecCache (UK) v0.4; EPG2MEI v0.96; Font Manager 1.0d; Extend v1.7; WSSkiller V2.12d; MyInfo B5.6; fsSave 1.1; PruneEPG 1.0; MyStuff 6.6-1;
Sig generated by EMJB's MyInfo.tap on 3/5/21
Post Reply